Bosch E92-10 — Control board configuration error — stored program does not match model

What Bosch E92-10 error means on your dishwasher

Error code E92-10 is a sub-code of E92 that specifically indicates the main control board’s stored configuration does not match the expected parameters for the dishwasher model. The “10” suffix points to a programming or EEPROM data issue on the main board rather than a physical communication failure. If you encounter the bosch e92-10 error, professional Bosch dishwasher repair may be needed.

Symptoms

• The dishwasher shows E92-10 (or E:92-10) on the display
• The unit powers on but cannot start any wash cycle
• The error appears consistently after every power cycle

Common causes

• Corrupted EEPROM data — power surges or electrical noise can corrupt the configuration data stored on the control board’s memory chip
• Incorrect replacement board — a new control board installed during a previous repair was not programmed with the correct model-specific configuration
• Firmware fault — a rare manufacturing defect in the board’s programming

See all Bosch dishwasher error codes for related fault codes and diagnostic steps.

Troubleshooting steps you can try

1. Power cycle — disconnect power at the breaker for 10 minutes. Restore power and check if the error clears. Repeat up to three times — some boards recover their configuration after multiple reset attempts.
2. Document the full code — note the exact display (E92-10) and your model number (found on the door edge label) before calling for service.
3. Check Bosch support — visit Bosch’s official dishwasher support page for model-specific troubleshooting guides and tech notes.

When to call a technician

E92-10 almost always requires the main control board to be reprogrammed or replaced. A technician uses Bosch diagnostic tools to read the board’s current configuration and either reprogram it with the correct data or install a new board. The control board is typically located behind the door panel or at the base of the dishwasher. Codes may vary by model generation and series. Schedule a certified Bosch technician for fast, reliable diagnosis and repair.